Rotogravure Cylinder Making Machinery

Correct Hue Shift
Start by consulting the cylinder department. Check the register and make sure the cells are configured properly. Next, adjust the electric eyes, lower the dryer temperature, and finally, add fresh ink to the fountain (and add less slip compound).

Fix Problems with Drying In
Drying in is when ink dries on the cylinder walls, and there are typically only two causes: the wrong press conditions, or the ink drying too fast. To correct the press conditions, there are a number of things you can do:
Check the air velocity, oven temperature, and doctor blade angles
Wipe the cylinder
Remove the connected spot air system
Cool the fountains
Increase the speed of the press
If the ink is drying too fast, you should add a slow-drying solvent, decrease the viscosity, and notify the ink supplier.

Know How to Address an Uneven Appearance
Dark and light areas that are described as puddling, mottling, and volcanoes can be attributed to paper surface, large cells in the cylinder, pressure on the impression roller, and overly thinned ink. Fixing the issue may call for adjusting the ink viscosity, consulting the cylinder department, or adjusting the roller.

Stop Scuffing in Its Tracks
Scuffs or scratches in the ink are likely caused by the ink itself, the press conditions, or the paper. Here's what you can do to fix the problem:
Add wax or hardeners to the ink
Check and adjust the ink viscosity
Upgrade ink film integrity by changing the solvent system
Increase the oven temperature
Check the paper abrasion

Don’t Let Strike-Through Get You Down
Lacquer the cylinder, add a pigment extender, and increase the ink viscosity, the oven temperature, and the air velocity. If that doesn’t fix the problem, the issue may be the paper. The fix in that case is switching to a less absorbent paper. Otherwise, it may be the ink holdout, in which case you should consult the manufacturer.

Adjust the Color Strength
When the color is too strong, you can address the problem by lacquering in part of the cylinder to reduce cell volume, consulting the cylinder department, adding solvent to reduce the ink viscosity, and adding a clear Extender. When the color is too weak, these fixes might help:
Increasing cell volume by re-etching the cylinder
Increasing the ink viscosity
Cleaning the cylinder
Flattening the angle
Replacing the roller
Adding toner
Checking the auto ink batcher

Improve Ink Mileage
Improve the startup procedure to reduce waste. Use a less absorbent paper, get the prescribed viscosity by adjusting the ink­–solvent ratio, or reformulate the ink if the ink is penetrating the stock too fast. You can also check with the manufacturer about the ink gravity values.

Prevent Ink from Frothing and Foaming
First, try using a hose to introduce ink to the pan rather than letting it fall. Next, inspect the pump for leaks, or adjust the pump speed to reduce agitation. You can also try adjusting the ink viscosity, or adding a defoamer compound.

Adjust the Gloss Levels
When the gloss is too high, reduce viscosity by adding a solvent, or use a pigmented extender. To increase low gloss, add a gloss extender, increase the viscosity, or use less solvent.

Ensure Consistent Color Reproduction
Color variation can be caused by a number of issues. Here are some tried and true ways to troubleshoot them:
Adopt a single set of procedures for all operators
Always use measured amounts
Equalize or calibrate the flow rates
Clean and inspect the equipment between presses
Use similar ink strengths